Hard Hat Accessories

The Halo Light ™ Accessories

Accessories for The Halo Light include the Field Locker, a rechargeable battery pack, a car charger, a standard charger, and replacement clips. Everything you need to get maximum use with minimal downtime.

The Halo Light 10-unit Field Locker & Charging Station is a rugged transport and storage case that holds 10 complete Halo Light systems and provides a mobile charging solution. The Field Locker is ideal for job site deployment — offering a single solution for secure storage, charging, and transport. Charge in any standard 3-prong 110V AC outlet. When it’s time to move, close it up, and everything is ready to be hauled to the next site.

  • Dimensions: 83.3cm x 53.6cm x 42.7cm (32.8” x 21.1” x 16.8”)
  • Power cord length: 4.3m (14ft)
  • Net Weight: 23.1kg (51lbs)
  • Power Surge Protector: 125V / 15A / 60Hz / 1875W
  • UL Clamping Voltage (3-line): UL 1449 400V
  • IP Rating: 67

A replacement or secondary lithium-ion battery pack and cable. When you need more juice, simply swap out one battery pack for another and keep going. It provides up to 12 hours of full power use for The Halo Light once fully charged. Charge using The Halo Light Standard Charger or The Halo Light Car Charger.

  • Dimensions: 38 x 76 x 96mm (not including cord)
  • Cable length: 109cm, partially coiled
  • Weight: 322g
  • Battery life: 12 hours minimum at 20°C
  • Battery recharge time: up to 5 hours
  • Safety Standards: IEC62133, UL2054
  • IP Rating 67

A replacement or secondary charger for charging The Halo Light Battery Pack from a standard electrical outlet. Supports 100-240V.

  • Dimensions: 26 x 40 x 108mm
  • Weight: 76g
  • Power Input: 100-240V, 50/60Hz, 0.3 amps
  • Power Output: 8.4V, 1.2 amps
  • Safety Standards: IEC6059-1

A secondary charger for charging The Halo Light Battery Pack while mobile, using a standard vehicle DC power connector/cigarette lighter.

  • Dimensions: 29 x 38 x 90mm (not including cord)
  • Weight: 61g
  • Power Input: 12-24V
  • Power Output: 8.4V, 1.0 amps

A complete set of four replacement tempered spring steel tension clips found on the inner ring of The Halo Light. Simply pop out the old clips with a small flathead screwdriver and snap the new set in.

  • Dimensions: 23 x 22 x 19mm (per clip)
  • Weight: 3g (per clip)